2002 Ford Windstar Coolant Temperature Sensor Location Ford Fixya Source: coolant temperature sensor on a saturn 2002 sl1. where is it loca. the coolant temp sensor is on the driver's side of the engine in the head. if you remove the lid to the airbox and lift the intake tube, you will be able to reach it easily. to remove the connector, you just squeeze it. then use a socket or a wrench to remove the coolant. Do you have a schematic showing the location for a 2002 ford windstar dpfe sensor its almost directly in the middle but just to the right, behind the radiator, small square box about 2 x 3 inches with a three wire connector and two short vacuum lines underneath. stand directly in front and look straight down.
2002 Ford Windstar Coolant Temperature Sensor Location Ford Fixya Battery good power to the starter 2000 ford windstar radio works turn ignition on get nothing 3.8 eng. no power in engine fuse box compartment 1 relay warm & another clicks in fuse box under #1 try starting the car in neutral, if no start replace the park and neutral safty switch. #2 check for a faulty starter solenoid. #3 check for a faulty. The windstar name remained until 2004, when ford redesigned the minivan and renamed it the freestar. the 2002 windstar's 200 horsepower, 3.8 liter v 6 has a small sensor the coolant temperature sensor that measures the temperature of the engine coolant and relays the information to the vehicle's computer. Here are the directions specific to your vehicle for replacement and the two attached pictures correlate with these directions: 1. disconnect the battery ground cable. 2. partially drain the cooling system. 3. disconnect the engine coolant temperature (ect) sensor electrical connector. 2002 ford windstar sel 3.8l v6. check power steering fluid level. power steering fluid is easy to check and many people (mechanics included) often forget about learn how here. 2002 ford windstar sel 3.8l v6. replace the front turn signal. if your blinker doesn't blink, or blinks rapidly, you likely have a burnt out bulb.
Ford Coolant Temp Sensor Location Here are the directions specific to your vehicle for replacement and the two attached pictures correlate with these directions: 1. disconnect the battery ground cable. 2. partially drain the cooling system. 3. disconnect the engine coolant temperature (ect) sensor electrical connector. 2002 ford windstar sel 3.8l v6. check power steering fluid level. power steering fluid is easy to check and many people (mechanics included) often forget about learn how here. 2002 ford windstar sel 3.8l v6. replace the front turn signal. if your blinker doesn't blink, or blinks rapidly, you likely have a burnt out bulb. Firmly grasp the electrical connector and gently push it back onto the coolant sensor until you hear an audible click signaling the complete installation of the connector. 6. refill the cooling system. once the sensor installation is complete, close the radiator drain valve and refill the system with coolant. Low coolant. if the engine coolant level isn’t high enough to keep pressure in the engine it will run hot. but, there won’t be enough coolant to reach the temperature sensor. without the coolant hitting the sensor, the temp reading will be significantly lower than the actual engine temp. your windstar’s radiator fan will not kick on.
Comments are closed.