2003 Chevy Impala Q A Engine Radiator Cooling System More This is from the service manual and cooling system description: the bcm will request low speed cooling fan operation from the pcm under the following conditions: engine coolant temperature exceeds approximately 103°c (217°f). when a c is requested and the ambient temperature is more than 50°c (122°f). 7) move the airbox pcm enough to gain easier access to upper radiator hose and electric fans. 8) remove the lower air dam underneath the bumper 4 10mm bolts secure it in place. 9) remove the radiator cap. 10) disconnect the lower radiator hose from the radiator. this will drain your antifreeze, so make sure.
Radiator Components For 2003 Chevrolet Impala Cheapest Gm Parts Fill up the radiator with distilled water and run the engine. turn off the engine and drain the water, fill up the radiator with antifreeze until you have a 50 50 coolant distilled water mixture and burp the system. like the oil in your impala, coolant gets dirty over time and loses its ability to cool down your 3.4 liter engine. The cooling system in a 2003 chevy impala is comprised of several key components that work together to regulate and dissipate heat from the engine. these components include the radiator, water pump, thermostat, hoses, and coolant. understanding the role of each component is essential for maintaining the proper functioning of the cooling system. [diagram of 2003 chevrolet impala cooling system] in this diagram, the main components of the cooling system are labeled as follows: radiator: this is a heat exchanger that is responsible for dissipating heat from the engine coolant. radiator fan: this is a fan that helps to cool the radiator by blowing air through it. Hi, my employee has a 2003 chevy impala ls 3.8 or "3800" which he recently flushed the radiator because he has been has had hotter temps than normal. his wife drove to the grocery store & said car was spraying coolanton the belts. he told her when done shopping drive straight home ( without checking or adding water i found out this morning !.
Cooling System For 2003 Chevrolet Impala Gm Parts Online [diagram of 2003 chevrolet impala cooling system] in this diagram, the main components of the cooling system are labeled as follows: radiator: this is a heat exchanger that is responsible for dissipating heat from the engine coolant. radiator fan: this is a fan that helps to cool the radiator by blowing air through it. Hi, my employee has a 2003 chevy impala ls 3.8 or "3800" which he recently flushed the radiator because he has been has had hotter temps than normal. his wife drove to the grocery store & said car was spraying coolanton the belts. he told her when done shopping drive straight home ( without checking or adding water i found out this morning !. Asked by tismeinaz nov 20, 2014 at 07:58 pm about the 2003 chevrolet impala ls fwd. question type: maintenance & repair. we have put in a new radiator, new water pump and a new thermostat but the car still runs hot. it is a 2003 chevy impala. please help if you have a suggestion. Cooling fan control 3.8l (l36) the engine cooling fan system consists of 2 electrical cooling fans and 3 fan relays. the relays are arranged in a series parallel configuration that allows the powertrain control module (pcm) to operate both fans together at low or high speeds.
Comments are closed.