4 0 L Sohc Supercharger Kit How To Complete Ford Truck Enthusiasts Locate the fuel injection vac line and connect it to the 3 8” barb located beside the supercharger bypass valve. locate the fuel vapor return line. cut off the press fit connection and reconnect it to the remaining 3 8” barb on the moddbox intake manifold. secure the hoses with the provided hose clamps. Description. supercharger installation kit. *this kit does not include a supercharger. compatible with the following 4.0l sohc engine equipped models: 2004 2011 ford ranger. 2004 2010 mazda b4000. below are the hp potentials for an engine with stock internals (based on dynos performed at 400m elevation and tunes): power.
Ford Ranger Supercharger Kit 4 0 Sohc Ford ranger owners have increased the horsepower of their 4.0 ohv and 4.0 sohc engines by adding a supercharger. currently there is only a kit out there for the 4.0 sohc engine, and you need to provide your own supercharger. others have made their own custom mounts to install a supercharger on their 4.0 ohv engine. see: supercharging a ford. Remove the hose connector fitting. set the hose connector fitting aside for later use. locate the 1 5 8” diameter radiator to thermostat coolant hose. relocate the coolant hose to be in front of the oil cap and around the ac line as illustrated. cut approximately 5” to 6” off of the hose and re secure it to the radiator. Tape and label the vac line if necessary. unbolt the egr valve (2 – 12mm bolts). remove egr valve by disconnecting the egr tube. set the egr valve aside for later use. unplug the tps sensor. tape and label the plug if necessary. remove the throttle cable from the throttle body valve. Supercharger installation kit *this kit does not include a supercharger compatible with the following 4.0l sohc engine equipped models: 2001 2003 ford ranger (may be earlier years – contact for compatibility) 2001 2003 mazda b4000 (may be earlier years – contact for compatibility) below are the hp potentials for an engine with stock internals (based on view article.
Ford Ranger Supercharger Kit 4 0 Sohc Tape and label the vac line if necessary. unbolt the egr valve (2 – 12mm bolts). remove egr valve by disconnecting the egr tube. set the egr valve aside for later use. unplug the tps sensor. tape and label the plug if necessary. remove the throttle cable from the throttle body valve. Supercharger installation kit *this kit does not include a supercharger compatible with the following 4.0l sohc engine equipped models: 2001 2003 ford ranger (may be earlier years – contact for compatibility) 2001 2003 mazda b4000 (may be earlier years – contact for compatibility) below are the hp potentials for an engine with stock internals (based on view article. This started as a 4.0 ohv swap in an older ford ranger. the computer i used was from a 1994 ford ranger. the maf is also from a 1994 ford ranger and the afr (air fuel ratio) stays consistent around 14.6 to 14.8 under light to medium throttle and will stay around 13.4 to 13.6 under heavy to full throttle. the last issue i found was the intake i. But i haven't seen a complete and thorough "how to" supercharger install for the 4.0l sohc engine (specifically for ford ranger 2dr explorer sport trac & b4000). so here it goes. if you obtain a moddbox installation kit and any eaton m90 supercharger (89 95 either style inlet), just follow the following instructions and you're good to go.
Comments are closed.