Ford Escape 01 07 Blower Motor Removal Youtube 01 07 ford escape blower motor removaldisclaimer:this video is not meant to be a definitive how to.always consult a professional repair manual before startin. Buy now!new heater blower motor with fan cage from 1aauto 1aau.to ia 1ahcx001791a auto shows you how to repair, install, fix, change or replace a.
How To Replace Blower Motor With Fan Cage 01 07 Ford Escape Youtube Pull out the blower motor. step 2 :preparing the new blower motor. 2:09. attach the foam pad to the new blower motor with contact cement. attach the gasket to the new blower motor with contact cement. put the plastic cover onto the new blower motor. step 3 :installing the new blower motor. 2:34. After that you can remove the plug in the middle and in the end pull out the cable from the plastic clip on the right. after you remove that cable, you will ease your access to the blower motor bolts. there are three of them, similar to the one shown in the picture below, that can be removed with an 8 mm socket wrench. 2 (part of 19805) blower motor vent tube 3 (19805) blower motor removal and installation 1. disconnect the blower motor electrical connector. 2. release the 2 blower motor vent tube clips and pull the vent tube down until it is disengaged from the heater core and evaporator core housing. 3. note: the carpet below the blower motor must. Exactly as atlcarl69 mentioned. the passage to the blower starts from those flaps. after mice gets into this area there is a book size opening directly goes into the blower motor. its easy to remove those big plastic peaces (wipers must be removed) and you can see this opening and blower fan inside (from engine side).
How To Change The Blower Motor On Ford Escape 2001 2007 Reset Service 2 (part of 19805) blower motor vent tube 3 (19805) blower motor removal and installation 1. disconnect the blower motor electrical connector. 2. release the 2 blower motor vent tube clips and pull the vent tube down until it is disengaged from the heater core and evaporator core housing. 3. note: the carpet below the blower motor must. Exactly as atlcarl69 mentioned. the passage to the blower starts from those flaps. after mice gets into this area there is a book size opening directly goes into the blower motor. its easy to remove those big plastic peaces (wipers must be removed) and you can see this opening and blower fan inside (from engine side). Step by step guide on how to replace remove install blower motor resistor on ford escape suv ( 2008 | 2009 | 2010 | 2011 | 2012 | xl | xlt | limited | hy. Step 2: remove the blower motor. the blower motor will be attached at the bottom of the plastic climate control unit, usually with screws. disconnect the wires from the blower motor. remove the screws holding the blower motor to the climate control unit. carefully slide the motor out of the housing—there will be a plastic wheel on the far.
Comments are closed.