How To Find The Correct Lotos Plasma Cutter Consumables And Part Guide: fabricationguy lotos consumables hey guys in this video i wanted to provide you all with our guide on how to find the correct consumables. Signs that you need a new set of consumables include: excessively big hole in the torch nozzle compared to new nozzles. irregularly shaped nozzle hole (it should be round) slightly angled cuts that were produced from a torch held at 90 degrees. large hole (crater) in the electrode tip compared to a new electrode. plugged holes in the shield cap.
How To Identify The Correct Consumables For Lotos Plasma Cutters Connect your plasma cutting torch and ground cable to the front panel of the machine (figure 1.5). attach the ground clamp to the metal work piece that you plan to cut. make sure that you cannot pull out the ground connection from the machine input. the metal work piece should be securely attached. Plasma cutting function. use the gas hose to connect to one of the terminals on the air regulator and connect the other terminals to the copper tub. connect the copper nut of the cutting torch to the knob on the panel board. connect the plug of the ground clamp to the ( ) socket on the front panel. Place and hold the torch vertical at the edge of the plate. pull the trigger to energize the pilot arc. the cutting arc will start when the nozzle is moved closer to the edge of the work piece. when the cutting arc has cut through the edge of the plate, start moving evenly in the direction you wish to cut. Lotos ltp5500d. i’ve been using the lotos ltp5500d cnc for the last 2.5 years. the ltp5000 is not compatible, the ltp5500d (if it’s the cnc version) is. i use the cnc port for torch control and second connector for thc sensing. update: apparently there is a difference between the ltp5500d and the ltp5500d cnc.
How To Identify The Correct Consumables For Lotos Plasma Cutters Place and hold the torch vertical at the edge of the plate. pull the trigger to energize the pilot arc. the cutting arc will start when the nozzle is moved closer to the edge of the work piece. when the cutting arc has cut through the edge of the plate, start moving evenly in the direction you wish to cut. Lotos ltp5500d. i’ve been using the lotos ltp5500d cnc for the last 2.5 years. the ltp5000 is not compatible, the ltp5500d (if it’s the cnc version) is. i use the cnc port for torch control and second connector for thc sensing. update: apparently there is a difference between the ltp5500d and the ltp5500d cnc. The ltp5000d will be easier to start with its pilot arc feature, allowing you to begin your cut while not touching the metal with the tip of your torch. the lt5000d you may experience a little bit of blow back when you start your cut as the tip of the torch has to touch the metal in order to start. this blow back will more severe on thicker. Double check to make sure the part numbers you choose match the numbers shown on your system or operator’s manual. plasma cutter tip no. 2: set your amperage by your plasma cutting consumables amperage usually isn’t included in cut charts because the amperage you choose should be based on the amperage of your nozzle.
Comments are closed.