Reference Plane Or Reference Line Quadmeta Reference line is a guideline which has 4 reference planes whereas curved lines offer 2 reference planes. it is acting like 2d or 3d lines but is not visible in the project when is loaded. it is normally used to constraint angles (rotation) in the family editor if needed (i prefer to just use 2d 3d line and constraint to the reference plane). Reply. message 3 of 6. loboarch. in reply to: anonymous. 05 09 2011 05:38 am. because a reference line has logical endpoints (as opposed to a reference plane which does not) you can lock the end points into position and you can use angle types of parameters on them. so the door swing example is a good one. any family where you need the plane of.
Reference Plane Or Reference Line Quadmeta Points In 3d Sketch On the other hand reference lines are used by revit technicians for developing family framework. uses of reference plane and reference line. when family geometry is created by revit technicians placement of dimensions between reference planes and reference lines becomes utmost crucial. that means while creating family parameters, the use of. Difference between reference planes and reference lines revit. what is the difference between reference planes and reference lines? a reference plane is an infinite plane that servers as a guide for drawing lines and geometry. a reference line creates a line similar to a reference plane, but that has logical start and end points. 5 set the origin planes. to set the origin of a family, check the defines origin box. set the origin to two reference planes: vertical and horizontal. for example, this family origin is located at the center of the family (as indicated by the 0,0 text). when the dimensions are changed, it will be relative to the center. Steps. go to the create tab > datum panel > click reference plane (shortcut: rp). draw a reference plane on the floor plan view. draw three more reference planes on the plan view, one for each face of the cube. name each reference plane by clicking on its label. switch to the front view.
Reference Plane Or Reference Line Quadmeta Reference Lines In 5 set the origin planes. to set the origin of a family, check the defines origin box. set the origin to two reference planes: vertical and horizontal. for example, this family origin is located at the center of the family (as indicated by the 0,0 text). when the dimensions are changed, it will be relative to the center. Steps. go to the create tab > datum panel > click reference plane (shortcut: rp). draw a reference plane on the floor plan view. draw three more reference planes on the plan view, one for each face of the cube. name each reference plane by clicking on its label. switch to the front view. A metal deck family created within a framework of reference planes. to lay out reference planes. click create tab datum panel (reference plane). specify a start point and an end point for the reference plane. name the reference plane so that you can identify it in when you open other views: select the reference plane, and on the properties. Use the reference plane tool to draw reference planes to use as a guideline in your design. reference planes are an integral part of family creation. reference planes display in each plan view that you create for a model. use the line tool or the pick line tool to draw a reference plane. name each reference plane so you can assign it to be the.
Comments are closed.