Service Bulletin Vw Coolant System Flushing Re creating the engine's condition as it was when it left the factory will ensure that your new components last until the next 75,000 mile change interval. example 2) vw coolant contamination caused by coolant flush products. image 1) original water pump removed from an audi 2.7t with approximately 80,000 miles. 27. switch the dt 45096 transflow to flush. 28. flush the vehicle cooler and lines using 2 quarts of hp fluid. ⇒ flush 1 quart of fluid through the lines, then switch the hose connections and flush 1 quart of fluid in the opposite direction. 29. remove the dt 51190 dt 45096 31 assembly. 30. if equipped, install the thermal by pass block from.
Service Bulletin Vw Coolant System Flushing • refill the cooling system using the vas 6096 coolant system charge kit and vag 1274 8 adapter. refer to elsaweb repair manual engine 19 cooling system for instructions on filling. • when the system is full remove the tool and fitting from the coolant reservoir. • install the fill cap onto the coolant reservoir. 9291 posts · joined 1999. #5 · aug 7, 2019. usually on the mk7 you flush and fill when the coolant pump or housing leaks. mine was done at 48,000 miles. seriously though there is no maintenance schedule for coolant because its a "lifetime" fill. 4 5 years is overkill though. if you really wanted to change it i wouldn't do it until 8 10 years. Vw say's to flush your cooling system with a 50 50 mix of new coolant, running it up to temp then idle for 2 minutes, then drain again and refill with 50 50 mix for the final fill. they don't mention using any flushing agent's, just new 50 50 mix. the drain the coolant there are a few hoses to remove. there isn't a petcock like most vehicles. Volkswagen tsb 01a3 make: volkswagen number: 01a3 title: coolant flush (nvlw) u.s. only date: 9 16 2013 models: 2014 passat summary: this update has been proactively released to ensure proper coolant quality and performance of the engine cooling system. this update is in effect until removed.
Service Bulletin Vw Coolant System Flushing Vw say's to flush your cooling system with a 50 50 mix of new coolant, running it up to temp then idle for 2 minutes, then drain again and refill with 50 50 mix for the final fill. they don't mention using any flushing agent's, just new 50 50 mix. the drain the coolant there are a few hoses to remove. there isn't a petcock like most vehicles. Volkswagen tsb 01a3 make: volkswagen number: 01a3 title: coolant flush (nvlw) u.s. only date: 9 16 2013 models: 2014 passat summary: this update has been proactively released to ensure proper coolant quality and performance of the engine cooling system. this update is in effect until removed. Never fill or top off with full concentrate g13, g12 , g12 , or g11 vw coolant antifreeze. your vw coolant antifreeze should never exceed an coolant ratio of 60%. if it's over 60%, an inefficient vw cooling system will result, decreasing flow through the radiator along with poor heat transfer through the engine block. 2018 volkswagen atlas se 3.6l v6. add brake fluid. if your brake fluid is a little low, learn how to add some here. ignoring a low level leads to big problems. 2018 volkswagen atlas se 3.6l v6. add air to your tires. properly inflated tires is the easiest way to improve fuel economy. the right tire pressure is not on the side of your tire btw.
Comments are closed.