Swap Change The 3d Model Used In A Drawing View Autodesk Inventor If you have an inventor drawing and need to change swap the 3d model used in all the drawing views, drafting the drawing again could be a timely endeavour. Make a drawing file that will hold all the views of the various parts. use copy and paste to move the views from the temp drawing to the final drawing file. go back to the temp drawing and use the replace model reference command to change source parts. repeat the copy and paste operation to add the new part views to the final drawing file.
Solved Autodesk Inventor Drawing Place 3d Model View Autodesk Community Drawing views of models. a drawing view is a 2d representation of a 3d digital prototype that is placed on a drawing sheet. the commands for views in inventor are like view types in drafting. the two types of view commands in inventor are author and modify. author commands create new views. they are located in the author panel of the ribbon. Do one of the following: to create a view, click place views tab create panel base on the ribbon. then select a model file in the drawing view dialog box. to change orientation of an existing view, double click the view. right click the view cube, and click custom view orientation to enter the custom view environment. Use custom view orientation to orient the view, follow these steps: while the drawing view dialog is open, right click the view cube > custom view orientation select the face. click look at in the navigation bar or custom view > navigate > look at. confirm with finish custom view. change other options as needed and confirm with ok. was this. On the "manage" tab, use the function "replace model reference". select the existing model reference in the list and click on the small button "select new model". select the new model (assembly or part) and press ok. note: it may be necessary to adapt the scale and the position of all elements in the drawing to the new size of the drawing views.
How Can I Change The Presentation View In A Drawing In Inventor Use custom view orientation to orient the view, follow these steps: while the drawing view dialog is open, right click the view cube > custom view orientation select the face. click look at in the navigation bar or custom view > navigate > look at. confirm with finish custom view. change other options as needed and confirm with ok. was this. On the "manage" tab, use the function "replace model reference". select the existing model reference in the list and click on the small button "select new model". select the new model (assembly or part) and press ok. note: it may be necessary to adapt the scale and the position of all elements in the drawing to the new size of the drawing views. On the ribbon, click manage tab, modify panel, replace model reference. the replace model reference dialog box opens and lists all the top level model references contained in the drawing. click the reference model to replace. the select new model command enables, so you can browse for a new model to replace the original model reference. If a design change is made to a model state that is used in a drawing view, it will update to reflect the change when next opened. any associated parts lists or general tables will also update.
How To Re Orient An Inventor Model For A Drawing View On the ribbon, click manage tab, modify panel, replace model reference. the replace model reference dialog box opens and lists all the top level model references contained in the drawing. click the reference model to replace. the select new model command enables, so you can browse for a new model to replace the original model reference. If a design change is made to a model state that is used in a drawing view, it will update to reflect the change when next opened. any associated parts lists or general tables will also update.
Solved Change Drawing S Projected View Autodesk Community
Module 3 Viewing The 2d Sketch And 3d Model Introduction To Drafting
Comments are closed.